RAID Failures can be devastating
CBL can help get your data back and your business back up and running
RAID and Server Data Recovery - Multiple Drive Failures
To Speak With a Data Recovery Specialist call 1.800.551.3917 (24 hr toll-free hotline)
Rebuild your RAID while CBL Data Recovery rescues your data
Despite the built-in redundancy and active-failover capability of most RAID architectures, data loss is still very possible. When a RAID array fails, it’s important to remember it is the data that is valuable – the hardware is can be replaced quickly and affordably while a data recovery specialist retrieves your lost data from the affected drives.
It is important to understand why and what should be done during an array failure, particularly a multi-disk failure. If only one drive fails, the array will continue to allow read and write access to the data, but if a second drive were to fail on 5 drive system, then all the data on the array could potentially be lost.
Multiple-drive failures do happen and can be caused by component quality issues, recent firmware changes or by environmental factors such as heat and vibration, power surges. If the array develops a problem, do not assume that you will be able to fix it yourself. Hoping the problem will clear up by repeatedly resetting or power-cycling the array can make the problem worse.
Any failed drives must be replaced immediately, but since the array will appear to be working normally, this can easily be overlooked. Until the faulty drive is replaced and the array rebuilt, all the data on the array is potentially vulnerable to a second drive failure.
If the RAID set is quickly removed and handed to a specialist, they will have a better chance of successfully recovering the data. New drives can be installed and the applications are likely to be back on line with less delay.
|RAID and Server Data Recovery Information:|
Digital and Graphic Arts
Blade Server recovery
Enterprise OS Recovery
|Rapid RAID Response Service|
Whatever the cause of your hardware failure and data loss, this is what you should do right now:
- Do not panic.
- If a drive is making unusual mechanical noises, turn it off immediately and get assistance.
- Do not replace the failed drive with a drive that was part of a previous RAID system.
- Have a valid backup before making hardware or software changes.
- Try to restore the backup to a secondary system rather than the failed system.
- Label the drives with their position in a RAID array.
- Do not run volume repair utilities on suspected bad drives.
- Do not run defragmenter utilities on suspected bad drives.
- Do not attempt to repair the failed device.
- Contact a CBL Data Recovery expert at 1-800-551-3917.